Charcoal technique under normal circumstances, there is no high-quality and high level of operator skill is not grasp the performance of the machine, and charcoal technique is easy to learn, there are the basics of electrical machinery mechanic, after 2-3 days of training that operational, the company provides complete technical support for life. Actually charcoal technique is very simple, roughly on the following points: 1), tighten all screws connections, especially heating barrel three top wire, connected appliances and power lines. 2) Check all lubrication cylinder filling gear oil. 3) Check the power supply voltage is normal. 4), no-load start running five minutes, no card, touch and other anomalies, can be put into normal production. When the test machine in unusual circumstances necessary to stop immediately, to find the reasons for the no-load operation after troubleshooting. 5), the temperature control was adjusted to the desired temperature, when the temperature reaches a predetermined temperature, before boot, and the right amount of feed. 6), and gradually increase the feed rate until the normal production of qualified products, when normal production 30 minutes, indicating a successful test, the normal production. 7), no material in the hopper to make before stopping, and after stopping the screw propeller reverse one minute, so that the storage of materials within the thruster exit. 8), the body must be well grounded. As long as you keep in mind that more than 8:00, the operation of the charcoal is no problem. Of course there Mingyang charcoal for your backing. Let you greater ease.