Charcoal charcoal charcoal package of equipment _ What are the equipment? First, let's say it's the next process, the material was ground first, followed by drying, rods and carbonation. Corresponding device are: 1. grinder: This machine is the raw material crushed into <3mm, before forming, such as tree branches, plant stalks, bark, plates, etc., crushing speed of about 300kg / h, motor power 7.5kw , the device uses high-carbon steel blades, good speed and strong wind suction, stable, strong and durable, crushing effect. 2. Dryer: Dryer primary role is to smash after the drying of raw materials, since the trees fit inside the straw itself contains a certain amount of water, so the rods must be dried before molding material after drying moisture content less than 12%, the drying rate of 600kg / h, a feed diameter φ3mm - φ5mm, temperature at 190 ℃ --300 ℃, in the process of drying, stoker, and wood will do, per ton of raw material drying need 50kg of dry firewood. 3. The system of rods: rods machine is complete equipment of the most critical equipment, it is the role of broken sticks made of raw material after drying, specification: (φ50mm × length 500mm), the host motor is 11kw, heating Circle of 4.5kw, output 150--180kg / hour (large diameter rods machine φ80mm, yield: 250--280kg / h 4. carbonization furnace: carbonization stove is the last part of the device, after the rods into the mechanism stick, placed inside anaerobic carbonization furnace combustion, the carbonized, becoming black charcoal, charring furnace can be finished every 1.2 tons - 1.5 tons, motor 0.5kw, stove fitted with filters and smoke removal equipment, environmental protection equipment, no harm to human ecology. See here, you probably would have understood what charcoal equipment, the entire production of charcoal, charcoal equipment environmental pollution, its power consumption is the number? pulverizer containing straw and wood grinder mill, straw grinder 5.5kw-7.5kw, wood grinder 7.5kw-11kw (according to the needs of different types of device configuration), dryer 4kw, rods machine 15kw, charring furnace 1.5kw. it That is all the equipment required total power 26kw, but it is worth reminding that in the production process at the same time the device is not turned on, which is what is what open, so doing the daily consumption between 180-200 degrees.